Maintenance; Troubleshooting - Texi Master Plus Manual Del Usuario

EN

MAINTENANCE

The company provides life-long maintenance service for the garment
steamer. The maintenance for the first year will be free and the core will
be guaranteed to be maintained for 1 year without extra charge (except
for those damaged not due to quality problems.) As there is always the
sedimentation of water, hard water and water impurities inside and the
inner is kept under high temperature during operation, the carbonate waste
caused may gradually affect the heating procedure and the ironing. It is
advised to clean the inside of iron every three months so that it works at the
best condition.
Fouling cleaning in general: power off and take out of the rest water inside;
dissemble the clotfies rack, air pipe and kettle. Get 400g clean water with a
vessel and a bag of exclusive detergent (lOg/bag); put all the detergent into
the vessel and then pour it into the sink after stirring (see the picture). (Note:
water position. Do not leak the water out of the iron) Put it for 3 hours and
pour the water out of the sink. Repeatedly add the water for cleaning.
If there is severe fouling, use 2-3 bags of exclusive detergent and dissolve
it in 400g clean water. Put it for 16 hours and then pour the water out of it.
Repeatedly add the water for cleaning.

TROUBLESHOOTING

Fault
Completely out of work
Little steam
Water pouring out of the
kettle
Heating water in the kettle
36
Cause
Check the power
/the circuit fault
/the switch
Check whether the pipe is
blocked by the fouling and
whether the voltage is low
Check whether the kettle is
cracked or there is a hole in it
Check whether the pipe is
blocked
The air duct may be bent or
the sprayer sealed.
Texi Master Plus
How to settle
Professional maintainer
suggested
Use exclusive detergent for
cleaning.
Make the voltage stable.
Replace the kettle.
Eliminate the fouling or the
block.
Straighten the air duct and
do not seal the sprayer.