Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
7. Place base on a dry flat surface with locking bar in down position as shown. In front of the machine
(spout side).
Base
Locking Bar
Front of Machine (Spout Side)
8. Place receptacle on the base with juicer spout facing direction of locking bar. Settle receptacle into
alignment.
Lip
Juice Spout
Receptacle
Base
9. Place filter inside receptacle, matching the opening on its bottom to the screw peg connected to the
base.
Filter
Receptacle
P-6
All manuals and user guides at all-guides.com
10. Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the
holes in the
blade and turn clockwise until tightened. IMPORTANT: Do not
peg will break. Remove crescent tool and set aside. Do not leave tool inside juicer.
Crescent Tool
Filter
Blade Holes
11. Place lid with pulp guard attached on top of receptacle, making certain it is snugly aligned with the
pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar
up until it clicks into grooves located on both sides of the lid. Make sure locking bar is in the full
upright, locked position. IMPORTANT: The unit will not start until this bar is properly locked in place.
Lid with Pulp Guard
Receptacle
Pulp Collector
12. Insert pusher into chute. Always use pusher to feed fruits and vegetables into unit. Push gently,
never force. The blade will do the work.
Pusher
Chute
Lid with Pulp Guard
over tighten as the screw
Blade
P-7
Capítulos
Tabla de contenido
Solución de problemas
