5. START THE STIMULATION
Press the INCREASE button
for each channel until you
41
reach a comfortable level of stimulation. Press and hold the but-
ton to increase the amplitude continuously.
AUTO
AUTO
Note! Always increase the amplitude cautiously!
S
P
The treatment time is preset, but can be changed by using the timer function, see section TIMER.
An automatically activated key lock prevents unintentional changes during treatment. The key lock is
activated if no button is pressed for 10 seconds. Press any of the DECREASE buttons
to deactivate
the key lock.
When the program is finished, Remaining time "00:00" is flashing on the display.
AUTO
AUTO
S
P
The last used program is saved when the stimulator is turned off and then pre-selected the next time
the stimulator is turned on.
The stimulator turns off after 5 minutes of inactivity to spare batteries.
AUTO STIMULATION MODE
To provide a pain relieving effect, the level of stimulation should be perceived as a little bit stronger than
the pain intensity. Since the body initially adapts to the set level of stimulation, it is often required to
adjust the amplitude a couple of times to reach the optimal level of stimulation.
By using the Auto stimulation mode the amplitude is automatically adjusted, and the optimal level is
reached after a few minutes of stimulation.
To use the Auto stimulation mode:
Follow steps 1-4 in the section STEP-BY-STEP USE.
5. START THE AUTO TEST
Press the AUTO button
for the left or right channel. "AUTO" starts flashing on the display,
AUTO
AUTO
and the amplitude increases gradually.
S
P
6. FINISH THE AUTO TEST
Press the AUTO button
again when you feel the stimulation at a comfortable level.
AUTO
AUTO
S
P
If you press AUTO too late, or want to start again for any reason, press the AUTO button again to start
over.
7. REPEAT THE AUTO TEST FOR THE OTHER CHANNEL WITHIN 3 SECONDS
If you want to use the Auto stimulation mode for both channels, repeat steps 5-6 for the other channel.