3.4 Light distribution curve
3.5 Environment
The LED fixture is intended to be used in climate-controlled grow rooms and indoor farms. The product may be used in damp
environments but may not be used in wet environments or outdoors.
The product will operate in ambient temperatures from -20ºC to 40ºC but will function at optimal level between 20ºC to 30ºC.
The product will operate in 20% – 90% humidity, non-condensing.
3.6
Legal
This product is FCC, IC, CSA & CE certified compliant with LVD and EMC directive test standards.
4. SAFETY RECOMMENDATIONS AND WARNINGS
Carefully read the warnings below before using or working with the product!
WARNING!
Always adhere to the local rules and regulations when installing or using the LED fixture.
•
Do not open or disassemble the LED fixture as it contains no serviceable parts inside. Opening or modifying
•
the LED fixture can be dangerous and will void the warranty.
Do not use the LED fixture when either the LED fixture or its power cord are damaged. Replace the power cord
•
with correctly rated cord only.
Modifications to the cabling can lead to unwanted electromagnetic effects which may make the product not
•
comply with legal requirements.
Do not expose the LED fixture to:
•
Condensing humidity, heavy mist or direct spray;
Ambient temperatures outside the specified range;
Dust and contamination;
Direct sunlight during use or HID light that may heat up the driver.
•
Always disconnect the LED fixture from mains before performing any maintenance.
•
Always allow for a cool down period of at least 20-30 minutes before touching the LED light bars. Touching
the LED bars when the fixture is lit or immediately after may result in burns!
•
Natural convection removes heat away from the heatsink. In order for the system too properly cool itself, at
least 5cm of space is required between the fixture and the roof of your grow area.
Fig3. Light distribution plot.
Unit: cd
C0/180 , 114.9
C90/270 , 113.9