Uline H-9309 Manual Del Usuario

H-9309
DELUXE PORTABLE
SIGN BASE
TOOL NEEDED
Flathead Screwdriver
Sign Base x 1 Inner Support
Sleeve x 1
1. Insert inner support sleeve into center hole of sign
base, ensuring it sits on alignment pin inside bottom
of base. (See Figure 1A)
2. Insert pre-drilled pole over inner support sleeve and
through center hole of base, ensuring it lines up on
alignment pin. (See Figure 1A)
NOTE: Ensure end of pole with six mounting
holes is facing up.
3. Put security bolt into hole on side of sign base and
rotate pole so holes align with bolt. Screw in firmly,
ensuring it fits in hole in pole. Pole may need to
be turned or lifted slightly to ensure security bolt is
properly seated. Do not overtighten. (See Figure 1B)
NOTE: For increased stability and wind
resistance, add five to seven gallons of water
to base using ballast port. Sand can be
substituted for water.
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Pre-drilled Stabilizer
Pole x 1 Plate x 4
ASSEMBLY
Pour le français, consulter les pages 5-6.
Flange Nut Security
x 2 Bolt (1/4") x 1
Figure 1A
Pre-drilled
Pole
Inner
Support
Sleeve
Sign Base
Para Español, vea páginas 3-4.
Bolt (5/16") EZ-Grip
x 2 Handle x 1
Figure 1B
Security Bolt
Security
Bolt Hole
0521 IH-9309