Idiomas disponibles

Idiomas disponibles

H-9900, H-9901
H-9902, H-9903
GIANT STACKABLE
BIN ORGANIZER
Post x 4
INSTALLATION OF SELF-LEVELERS AND OPTIONAL CASTERS
Figure 1
Figure 2
Figure 3
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Shelf x 5
TO INSTALL SELF-LEVELERS
NOTE: If installing casters, do not install self-levelers.
1.
Make sure post is positioned as shown. (See Figure 1)
2. Insert self-leveler into open end of post.
3. Use a rubber mallet/hammer or tap on ground until self-leveler slides
into post.
4. Repeat steps 2 and 3 for other posts.
TO INSTALL OPTIONAL CASTERS
1.
Make sure post is positioned as shown. (See Figure 2)
2. Engage the wheel brakes to keep casters from rolling during assembly.
Use a rubber mallet to tap caster stems into posts. (See Figure 2)
INSTRUCTIONS FOR UNIT ASSEMBLY
NOTE: Only five of the six shelves included will be used.
1.
Start with the lowest shelf. Snap the interlocking pieces of a
shelf support (wide end down) around the post at the lowest
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to
the same place on the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to keep
the lowest shelf at least 6" above the floor.
Para en Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Shelf Support x 20
Self-Leveler x 4
0122 IH-9900
Tabla de contenido
loading

Resumen de contenidos para Uline H-9900

  • Página 1 Para en Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-9900, H-9901 H-9902, H-9903 1-800-295-5510 uline.com GIANT STACKABLE BIN ORGANIZER PARTS Post x 4 Shelf x 5 Shelf Support x 20 Self-Leveler x 4 INSTALLATION OF SELF-LEVELERS AND OPTIONAL CASTERS TO INSTALL SELF-LEVELERS NOTE: If installing casters, do not install self-levelers.
  • Página 2 (See Figure 6). Repeat to add the remaining shelves. 5. For H-9902, the bottom two shelves will each use two larger bins (Uline model # S-12551) and the top shelves will each use three smaller bins (Uline model # S-12550).
  • Página 3: Organizador De Gavetas Gigantes Estibables

    H-9900, H-9901 800-295-5510 H-9902, H-9903 uline.mx ORGANIZADOR DE GAVETAS GIGANTES ESTIBABLES PARTES 4 Postes 5 Repisas 20 Soportes para Repisa 4 Autoniveladores INSTALACIÓN DE AUTONIVELADORES Y RUEDAS OPCIONALES PARA INSTALAR AUTONIVELADORES NOTA: Si instala ruedas, no instale autoniveladores. Asegúrese de que el poste esté posicionado como se muestra.
  • Página 4: Continuación De Instrucciones Para Ensamble De La Unidad

    (Vea Diagrama 6). Repita para agregar las repisas restantes. 5. Para H-9902, las dos repisas inferiores usarán dos gavetas grandes cada una (modelo Uline # S-12551) y las repisas superiores usarán tres gavetas chicas cada una (modelo Uline # S-12550). Diagrama 6 NOTA: La repisa superior se debe instalar en la ranura superior de cada poste.
  • Página 5 H-9900, H-9901 1-800-295-5510 H-9902, H-9903 uline.ca SUPPORT DE RANGEMENT POUR BACS EMPILABLES GÉANTS PIÈCES Pied autonivelant x 4 Montant x 4 Tablette x 5 Support de tablette x 20 INSTALLATION DES PIEDS AUTONIVELANTS ET DES ROULETTES EN OPTION POUR INSTALLER LES PIEDS AUTONIVELANTS REMARQUE : Si vous installez des roulettes, n'nstallez pas les pieds...
  • Página 6 5. Pour le H-9902, les deux tablettes du bas nécessitent chacune deux bacs de grande taille (modèle Uline # S-12551), et les tablettes supérieures, trois bacs de petite taille (modèle Uline # S-12550). Figure 6 REMARQUE : Installez de préférence la tablette supérieure au niveau...

Este manual también es adecuado para:

H-9901H-9902H-9903

Tabla de contenido