Selco Unistep 3500 Instrucciones De Uso página 25

Cause Line fuse blown.
Solution Replace the faulty component.
Cause Faulty on/off switch.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
No output power (the system does not weld)
Cause Faulty torch trigger button.
Solution Replace the faulty component.
Contact the nearest service centre to have the sys-
tem repaired.
Cause The system has overheated (temperature alarm -
yellow LED on).
Solution Wait for the system to cool down without switching
it off.
Cause Incorrect earth connection.
Solution Earth the system correctly.
Read the paragraph "Installation ".
Cause Mains voltage out of range (yellow LED on).
Solution Bring the mains voltage within the power source
admissible range.
Connect the system correctly.
Read the paragraph "Connections ".
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
Incorrect output power
Cause Mains voltage out of range
Solution Connect the system correctly.
Read the paragraph "Connections ".
Cause Input mains phase missing.
Solution Connect the system correctly.
Read the paragraph "Connections ".
Cause Faulty electronics.
Solution Contact the nearest service centre to have the sys-
tem repaired.
Arc instability
Cause Insufficient shielding gas.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good condition.
Cause Incorrect welding parameters.
Solution Check the welding system carefully.
Contact the nearest service centre to have the sys-
tem repaired.
All manuals and user guides at all-guides.com
Excessive spatter
Cause Incorrect arc length.
Solution Decrease the distance between the electrode and
the piece.
Cause Incorrect welding parameters.
Solution Decrease the welding voltage.
Cause Incorrect arc regulation
Solution Use a higher setting inductive connection.
Cause Insufficient shielding gas.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good conditions.
Cause Incorrect welding mode.
Solution Decrease the torch angle.
Insufficient penetration
Cause Incorrect welding mode.
Solution Decrease the welding travel speed.
Cause Incorrect welding parameters.
Solution Increase the welding current.
Cause Incorrect edge preparation.
Solution Increase the chamfering.
Cause Incorrect earth connection.
Solution Earth the system correctly
Read the paragraph "Installation ".
Cause Pieces to be welded too big.
Solution Increase the welding current.
Sticking
Cause Incorrect welding parameters.
Solution Increase the welding current.
Cause Incorrect welding mode.
Solution Angle the torch more.
Cause Pieces to be welded too big.
Solution Increase the welding current.
Cause Incorrect arc regulation.
Solution Use a higher setting inductive connection.
Undercuts
Cause Incorrect welding parameters.
Solution Decrease the welding voltage.
Cause Incorrect welding mode.
Solution Decrease the side oscillation speed while filling.
Decrease the travel speed while welding.
Cause Insufficient shielding gas.
Solution Use gases suitable for the materials to be welded.
Oxidations
Cause Insufficient gas protection.
Solution Adjust the gas flow.
Check that the diffuser and the gas nozzle of the
torch are in good condition.
25