Lubrication; Checking The Work Contact Element (Wce); Adjusting The Fastener Penetration - Husky H1504FK-R Manual Del Usuario

The depth to which a fastener is driven is controlled by
the depth adjustment (E). The depth of drive is adjusted
to a maximum setting. Test fire a fastener and check
depth. If a change is desired loosen locking screw (F) slide
adjustment to desired position and retighten locking screw,
sliding the two members closer to decrease the depth of
drive, sliding the two members farther apart increases the
depth of drive. Test fire another fastener and check depth.
Repeat as necessary to achieve desired results. The
amount of air pressure required will vary depending on
the size of the fastener and the material being fastened.
Experiment with the air pressure setting to determine
the lowest setting that will consistently perform the job at
hand. Air pressure in excess of that required can cause
premature wear and/or damage to the tool. A rubber
no-mar tip (G) is provided to reduce marring of the work
surface. The rubber cushion can be pulled off to provide
increased depth of drive for toenailing applications.

LUBRICATION

The tool requires lubrication before using the tool for the
first time and before each use. If an inline oiler is used,
manual lubrication through the air inlet is not required on a
daily basis.
NOTICE:
The work surface can become damaged by excessive
lubrication. Proper lubrication is the owner s responsibility.
Failure to lubricate the tool properly will dramatically
shorten the life of the tool and void the warranty.
1) Disconnect the air supply from the
tool to add lubricant.
2) Turn the tool so the air inlet is facing
up. Place 4-5 drops of 30 W non-
detergent oil into air inlet. Do not
use detergent oils, oil additives or air
tool oils, air tool oils contain solvents
which will damage the tool's internal
components.
3) After adding oil, run tool briefly.
Wipe off any excess oil from the cap
exhaust.

CHECKING THE WORK CONTACT ELEMENT (WCE)

NOTICE:
Check the operation of the Work Contact Element (WCE) trip
mechanism before each use. The WCE must move Freely
without binding through its entire travel distance. The WCE
spring must return the WCE to its fully extended position
after being depressed. Do not operate the tool if the WCE trip
mechanism is not operating properly personal injury may occur.
All manuals and user guides at all-guides.com
OPERATION
1) Disconnect the air supply from the
2) Remove
3) Make sure the trigger and Work
4) Reconnect air supply to the tool.
5) Depress the Work Contact Element
6) Remove tool from the work surface.
7) Depress the Work Contact Element

ADJUSTING THE FASTENER PENETRATION

1) Regulate the air pressure to 70 PSI at the tool.
2) Connect the air supply and test for penetration by
27
E F
G
tool.
all fastener from
magazine.
Contact Element (WCE) move freely
up and down without sticking or
binding.
(WCE) against the work surface
without pulling the trigger. The tool
must not operate. Do not use the
tool if it operates without pulling the
trigger. Personal injury may result.
The Work Contact Element (WCE)
must return to its original down
position. Pull the trigger. The tool
must not operate. Do not use the tool
if it operates. Personal injury may
result.
(WCE) against work surface. Pull the
trigger. The tool must operate.
driving fasteners into a sample piece of wood. If the
fasteners do not achieve the desired penetration.
Adjust the air pressure to a higher setting until the
desired penetration is achieved. Do not exceed 120
PSI at the tool or durability of the tool will be reduced.
Fig. 9
the