Mx Onda MX-HE2663 Manual De Usuario E Instalacion página 48

Figure 11. The glass will be free after removing the profile, as shown in
Figure 12. Pull the released glass very carefully towards you, if it includes a
central glass it can also be removed in the same way, the outer glass is
fixed to the door frame. Once the crystals are clean, proceed to place them
in the reverse way to that described to extract them.
2. Remove the screws located on both sides (right and left) of the profile as
shown in Figure 13, then remove the profile by pulling it out as shown in
Figure 14. The glass will be free after removing the profile as shown in
Figure 15. Carefully pull the released glass towards you. If it includes a
central glass, it can also be removed in the same way. The outer glass is
fixed to the door frame. Once the crystals are clean, proceed to place them
in the reverse way to that described to extract them.
Replacing the interior light
Warning: Before changing the light bulb, disconnect the oven from the mains
(plug or magnetothermic switch). And make sure the oven is totally cool.
Remove the glass shield by turning it counterclockwise, use rubber gloves if
you have difficulty removing the glass shield.
Depending on the oven model purchased, the type of lamp varies, it can be
type G9 (Figure 16) or E14 (Figure 17). In the case of being type G9 to extract
the bulb pull it outwards, in the case of being type E14 unscrew the bulb by
turning it counterclockwise.
Fig. 10
Fig. 13
Fig. 11
Fig. 14
23
Fig. 12
Fig. 15