General Safety Rules - Felisatti RHF40/1100VERT Instrucciones De Servicio

GENERAL SAFETY RULES

WARNING! Read all instructions. Failure to
follow all instructions listed below may result in
"power tool" in all of the warnings listed below refers to your
mains operated (corded) power tool or battery operated
SAVE THESE INSTRUCTIONS
1) Work area
a) Keep work area clean and well lit. Cluttered and
b) Do not operate power tools in explosive
liquids, gases or dust. Power tools create sparks which
c) Keep children and bystanders away while
operating a power tool. Distractions can cause you to
2) Electrical safety
a) Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any adapter plugs
b) Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators.
c) Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase the
d) Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool. Keep
Damaged or entangled cords increase the risk of electric
e) When operating a power tool outdoors, use an
extension cord suitable for outdoor use.
f) If operating a power tool in a damp location
is unavoidable, use a residual current device (RCD)
protected supply.
3) Personal safety
a) Stay alert, watch what you are doing and use
common sense when operating a power tool. Do not
use a power tool while you are tired or under the
of inattention while operating power tools may result in
b) Use safety equipment. Always wear eye
protection. Safety equipment such as dust mask, non-
skid safety shoes, hard hat, or hearing protection used for
c) Avoid accidental starting. Ensure the switch is
d) Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key left attached
to a rotating part of the power tool may result in personal
e) Do not overreach. Keep proper footing and
balance at all times.
f) Dress properly. Do not wear loose clothing or
jewellery. Keep your hair, clothing and gloves away
from moving parts.
g) If devices are provided for the connection of
dust extraction and collection facilities, ensure these
are connected and properly used.
4) Power tool use and care
a) Do not force the power tool. Use the correct
power tool for your application.
b) Do not use the power tool if the switch does not
turn it on and off. Any power tool that cannot be controlled
c) Disconnect the plug from the power source
before making any adjustments, changing accessories,
or storing power tools. Such preventive safety measures
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power
tool. Power tools are dangerous in the hands of untrained
e) Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts and
any other condition that may affect the power tools
operation. If damaged, have the power tool repaired before
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are less
g) Use the power tool, accessories and tool bits
etc., in accordance with these instructions and in
the manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed.
for operations different from intended could result in a
5) Service
repair person using only identical replacement
parts.
WARNING!
A moment
SPECIFIC SAFETY AND WARNINGS
or silica stone, the dust produced is extremely harmful
dust, in compliance with current regulations on acci-
to a mains supply protected by a differential and ther-mal
cut-out switch, in accordance with regulations on low-
3