Inserting The Ash Clean-Out Tray; 12. Installing The Flame Broiler Components - Pit Boss PLATINUM LAREDO 1000 PB1000PL Instrucciones Y Recetas

Asador y ahumador de pellets de madera
Ocultar thumbs Ver también para PLATINUM LAREDO 1000 PB1000PL:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

11. INSERTING THE ASH CLEAN-OUT TRAY

Parts Required:
1
x
Ash Clean-out Tray (#16)
Installation:
Insert the Ash Clean-out Tray into the opening on the front panel
of the unit, below the Front Shelf. Ensure the Ash Clean-out Tray is
inserted completely to properly collect ash from the Main Barrel.

12. INSTALLING THE FLAME BROILER COMPONENTS

Parts Required:
1
x
Flame Broiler Slider (#4)
1
x
Flame Broiler Main Plate (#5)
1
x
Flame Broiler Adjusting Bar (#12)
1
x
Flame Broiler Adjusting Bar Handle (#13)
Installation:
Insert the Flame Broiler Main Plate into the Main Barrel, right side
first. Rest the Flame Broiler Main Plate on the built-in ledge (on the
inside right) of the Main Barrel that directs grease towards the grease
bucket. Slide the entire piece to the left side, and the two slots on the
Flame Broiler Main Plate will fit into the rounded ledge. The Flame
Broiler Main Plate will sit slightly at a downward angle. Note 12A.
IMPORTANT: If the flame broiler main plate is on the base of the
barrel, it is installed incorrectly. The flame broiler main plate should
sit at an angle, with the left side sitting higher than the right.
Improper installation of this part may result in damage to your main
grill barrel.
Place the Flame Broiler Slider on top of the Flame Broiler Main Plate,
covering the slotted openings. Ensure the raised tab is on the left,
to easily adjust for direct or indirect flame when cooking. Note
illustration 12B. Both flame broiler parts are lightly coated with oil to
avoid rusting when shipped.
Next, insert the Flame Broiler Adjusting Bar through the opening hole
on the left side of the Main Barrel. Add the Flame Broiler Adjusting
Bar Handle on the end outside the barrel. Next, slide the notched end
of the Flame Broiler Adjusting Bar into the locking tab on the Flame
Broiler Slider, giving you adjustable access to the Flame Broiler Slider
on the Main Plate. Note steps in 12C.
NOTE: When the flame broiler slider is open and direct flame is used,
do not leave the grill unattended for any period of time.
11
16
12A
5
12B
4
12C
A
12
A
B
13 12
B
5
11
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

10712

Tabla de contenido