Uline H-7787 Manual Del Usuario

Uline H-7787 Manual Del Usuario

Mesa para trabajo en equipo - estación de trabajo doble
Idiomas disponibles

Idiomas disponibles

H-7787
COLLABORATION TABLE –
DUAL WORKSTATION
TOOLS NEEDED
Allen Wrench
Phillips Screwdriver
(included)
(optional)
A
Bolt x 12
M6 x 45 mm
NOTE: Assemble on smooth, non-marring
surface to avoid scratching.
NOTE: Use Allen wrench to tighten bolts.
IMPORTANT! Check that all parts are included.
1.
Fit support rail over coresponding bracket on leg.
Use four M6 x 12 mm bolts (D) to secure each side of
support rail. Repeat for remaining support rails.
(See Figure 1)
NOTE: Do not fully tighten bolts until assembly
is complete.
Figure 1
Support Rail
Leg
PAGE 1 OF 6
1-800-295-5510
uline.com
Two Person Assembly
Recommended
PARTS
B
C
Bolt x 8
Bolt x 20
M6 x 15 mm
M6 x 60 mm
ASSEMBLY
D
Pour le français, consulter les pages 5-6.
D
Bolt x 32
M6 x 12 mm
2. Align support spacer with holes in center support rails.
Use two M6 x 60 mm bolts (C) to secure each end.
Repeat for remaining support spacer. (See Figure 2)
Figure 2
For optional privacy panel, continue to Step 3.
Otherwise, skip to Step 5.
Para Español, vea páginas 3-4.
F
Phillips Head Bolt x 8
M6 x 15 mm
(for optional privacy panel)
Support
Spacer
C
0921 IH-7787
Tabla de contenido
loading

Resumen de contenidos para Uline H-7787

  • Página 3: Mesa Para Trabajo En Equipo - Estación De Trabajo Doble

    H-7787 800-295-5510 uline.mx MESA PARA TRABAJO EN EQUIPO – ESTACIÓN DE TRABAJO DOBLE HERRAMIENTAS NECESARIAS Se Recomienda Armar Llave Allen Desarmador de Entre Dos Personas (incluida) Cruz (opcional) PARTES 12 Pernos 8 Pernos 20 Pernos 32 Pernos 8 Pernos de Cabeza de Cruz...
  • Página 4: Continuación Del Ensamble

    8. Asegure las cubiertas a los rieles de soporte usando Privacidad tres pernos M6 x 60 mm (C) por riel. (Vea Diagrama 5) 9. Apriete los pernos (D) instalados en el Paso 1. 800-295-5510 uline.mx PAGE 4 OF 6 0921 IH-7787...

Tabla de contenido