Kärcher G 2000 ET Manual Del Usuario página 6

Required tools
Screwdriver, small size (not supplied)
STEP 1:
Attach the handle to the frame of the
pressure washer. Align hole, insert
bolt, and tighten with knob.
STEP 2:
Push out the safety clip in the trigger-
gun using a small screwdriver.
Join high pressure hose and trigger-
gun together.
CAUTION
Do not run the engine with a high or low
oil level as this can cause engine dam-
age.
If you have further questions regarding
the engine, please refer to the engine
manual included with the unit.
STEP 1:
Check oil level. Oil level should al-
ways be between the "FULL" and
"ADD" marks on the dipstick.
Be sure the machine is level when
checking the oil level. (Refer to the
engine's operating manual for sea-
sonal grades.).
6
English
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
Push clip in until it locks and check
that it is securely fastened by pulling
on the high pressure hose.
STEP 3:
Insert the spray wand into the trigger
gun. Carefully press in against the
spring tension and twist into the
locked position.
We recommend that the oil be
changed after the first 5 hours of
use, then once every 25 hours.
STEP 2:
Fill gas tank with unleaded gasoline.
Do not use leaded gasoline.
STEP 3:
Connect the high pressure hose to
the unit's high pressure outlet.
STEP 4:
Connect garden hose to unit's water
inlet.
STEP 5:
Connect garden hose to the cold wa-
ter source and turn water on com-
pletely.
Do not use hot water.