HT-B458-E_A_M.book Page 6 Friday, June 12, 2009 9:45 AM
■
Storage
Do not store at the following places.
• Place that can easily get wet.
• Place that can be easily exposed to environmental factors such as high temperature,
moisture, direct sunlight, dust and salt.
• Place that is exposed to strong shocks or vibrations (for example, where possible to fall to
the floor easily).
Store in places out of the reach of children.
■
Disposal
When disposing the product, remove the rechargeable battery if necessary and please follow
local regulations on environmental protection.
The rechargeable battery on the product cannot be replaced.
Removing the Rechargeable Battery
This is not a repair procedure.
Once the unit is disassembled, it cannot be repaired.
1. Check that the brush does not operate, then remove the brush head from the main unit.
(Refer to Section 6.)
2. Remove the bottom cover of the main unit.
1) Use a flat head screwdriver to remove the cover
and the filter.
2) Use a cross head screwdriver to remove the screw
at the bottom of the main unit, and remove the
bottom cover.
3. Lift out the inner case.
Lift the inner case out while pressing one of the two
inner case hooks with a flat head screwdriver.
4. Remove the rechargeable battery.
Remove the tape, pull out the battery and cut the
cables at each end of the battery.
Notes:
• To prevent the removed battery from short-circuiting,
place sticky tape, sticky labels or similar material over its
+ and - terminals.
• Take care to avoid burns caused by leaking battery liquid
or a hot battery.
• Take care to avoid cuts from sharp edges.
• Dispose of the old batteries, main unit, brush head and
battery charger according to applicable local regulations.
6
Bottom cover
Screw
Filter
Cover
Inner case hooks