Troubleshooting; Cleaning The Drain Pump Filter - Kunft KWM5316 Manual De Instrucciones

Note!
• Do not use alcohol, solvents or chemical products to clean the
machine.

Cleaning the drain pump filter

Warning!
• Be careful of the hot water!
• Allow detergent solution to cool down.
• Unplug the machine to avoid electrical shock before washing.
• Drain pump filter can filter the yarns and small foreign matters from
the washing.
• Clean the filter periodically to ensure the normal operation of
washing machine.
Open the lower Rotate 90º C
cover cap and pull out the
emergency drain
hose, and take
off the hose cape
Open the filter Remove
by turning to the extraneous
counterclockwise matter
Caution!
• Make sure the valve cap and emergency drain hose are reinstalled
properly; the cap plates should be inserted aligned with the hole
plates otherwise water may leak.
• Some washing machines don't have an emergency drain hose, so
steps 2 and 3 can be skipped. Rotate the lower cover cap directly to
make the water run into the basin.
• When the washing machine is in use and depending on the
programme selected, there can be hot water in the pump. Never
remove the pump cover during a wash cycle, always wait until
26
After water
returns out, reset
the drain hose
Close the lower
cover cap
washing machine
the washing machine has finished the cycle and is empty. When
replacing the cover, ensure it is securely re-tightened.

2.4. Troubleshooting

If the washing machine does not work or if it stops working mid-
operation, try to find a solution to the problem. If you cannot find one,
contact the Customer Support Service.
Description Reason
Washing Door is not closed
machine properly
cannot start
Door can't be Washer's safety
opened protection design is
working
Water The connection
leakage between inlet pipe or
outlet hose is not tight
Detergent Detergent
residues is dampened
in the box or agglomerated
Indicator Disconnect the
or display power. The PC board
does not light or harness has a
connection problem
Abnormal
noise
Description Reason Solution
Door does not Restart after the door is closed
close properly
Check if clothes are stuck
Water injecting Check if the water pressure is too low
problem while
Straighten the water pipe
washing
Check if the inlet valve filter
is blocked
Overtime water Check if the drain hose is blocked
draining
Water overflow Restart the washing machine
Others Please try again. Contact
the Customer Support Service
if the problem persists
EN
KWM5316
Solution
Restart after the door
is closed
Check if the clothes
are stuck
Disconnect the power
and restart the washing
machine
Check and fasten
the water pipes
Clean up the outlet hose
Clean and wipe
the detergent box
Check if the power is shut
down and the power plug
is connected correctly
Check if the fixing (bolts)
have been removed
Check it's installed
on a solid and level floor
27