Sony HT-CT150 Manual De Instrucciones página 36

• If you connect the audio output of the video
component and the system using other than
an HDMI cable, no sound may be output
because of "BRAVIA" Sync. In this case, set
"CTRL HDMI" to "OFF" (page 21) or
connect the audio output jack directly to the
TV instead of the system.
If "PROTECTOR" and "PUSH POWER" appear
alternately in the front panel display.
Press ?/1 to turn off the system, and check
the following item after "STANDBY"
disappears.
• Is anything blocking the ventilation holes of
the system?
After checking the above item and fixing
any problems, turn on the system. If the
cause of the problem cannot be found even
after checking the above item, consult your
nearest Sony dealer.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the system for the operation.
1
Press ?/1 to turn on the power.
2
Press ?/1 while pressing INPUT
SELECTOR and VOLUME –.
"COLD RESET" appears and the system is
reset. AMP menu, sound field, etc., return to
the default settings.
36
US
Specifications
Formats supported by this
system
Digital input formats supported by this system
are as follows.
Format
Dolby Digital
DTS
Linear PCM (2ch)*
Linear PCM (5.1ch,
7.1ch)* (Only on
HDMI)
Dolby Digital Plus
Dolby True HD
DTS-HD
* Linear PCM accepts sampling frequencies of no
more than 48 kHz.
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(FTC)
for the U.S. model
Front L + Front R:
Amplifier section
U.S. models:
POWER OUTPUT (reference)
Front L/Front R/Center:
Subwoofer:
Canadian models:
POWER OUTPUT (rated)
Front L/Front R:
POWER OUTPUT (reference)
Front L/Front R/Center:
Subwoofer:
Supported/Not supported
a
a
a
a
×
×
×
With 4 ohms loads, both
channels driven, from 180 -
20,000 Hz; rated 50 Watts
per channel minimum RMS
power, with no more than 1
% total harmonic distortion
from 250 milli watts to
rated output.
85 W (per channel at
4 ohms, 1 kHz)
85 W (at 4 ohms, 100 Hz)
60 W + 60 W (at 4 ohms,
1 kHz, 1 % THD)
85 W (per channel at
4 ohms, 1 kHz)
85 W (at 4 ohms, 100 Hz)