Cleaning Instruction - MIA MP 1065N Instrucciones De Uso E Instrucciones De Seguridad

Attention: Watch exhausting-steam when opening the lid!
 During operation glottal stops can occur. This isn't a failure. The noise originates as a result
of thermal expansion of the heater and the heating plate.
 Don't touch the reflector with the hand, don't put flammable materials onto the pan.
 The heating element (ring) is positioned below the heating plate. Directly above the
ring of the heating element, the heating plate will get hotter than in other parts of the
heating plate.
After use switch back the temperature regulator to "OFF" first
pull out the plug from the plug socket and remove the automatic
temperature regulator not before cooling off the appliance.
Attention: Due to the temperature sensor of the temperature
regulator is still hot after use, first let the appliance cool
down.
C l e a n i n g i n s t r u c
C l e a n i n g i n s t r u c
Caution danger of electric shock! Never immerse the appliance, cord and plug into water.
Always disconnect the appliance from power supply before cleaning to avoid risk of electrical
shock.
Caution danger of burning! Always let the appliance cool down enough before cleaning and
storing.
NOTE: None of these parts are suitable for the dishwasher!
Before cleaning or storing pull out the mains plug and let the appliance cool down.

Don't use abrasive cleaning agents or scrubbing sponges to clean the pan surface!

Never use cleaning agents, nylon brush or metal brush!
Never immerse the pan into water or wash it under running water. Water can intrude
into the appliance and cause damage to the electric parts inside.

Clean the pan with a soft, sponge slightly damp and little soap suds, wipe again with sponge
slightly damp with some clear water and dry carefully with a soft cloth. After drying apply a thin
film of cooking oil onto the surface.

Clean the cap with a soft sponge and a little bit of rinsing-agent. Never use thinners, gasoline,
cleaning agents or chemical treated cloths as the surface could be damaged.

Clean the automatic temperature regulator with a soft paper towel or a dry and soft cloth. Never
wet clean the automatic temperature regulator unit. Electric shock or burn can occur if it comes
into contact with water or liquid. Never immerse the plug or cord into water!
t i o n
t i o n
21