Jocel JLR013989 Manual De Instrucciones página 56

2. Connected securely to a standpipe
Firstly, form a hook in the end of the drain hose using the "U" piece supplied.
Place the drain hose into your standpipe, which should have an internal
diameter of approximately 30mm thus ensuring there is an air break between
the drain hose and standpipe.
When discharging into a standpipe ensure that the top of the standpipe is no
more than 90cm and no less than 60cm above floor level.
❖ Water inlet connection
Connect the inlet hose supplied with the machine to a tap with a 3/4" thread.
Do not use previously employed hoses.
Installation should comply with local water authority and building regulations
requirements.
When there is a inlet valve at the back of the machine, it must be connected to
a cold water supply. If there are two inlet valve, one is connected to a cold water
supply and the other is connected to a hot water supply. Follow the indication of
the picture below to complete the connection.
56