Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
USAGE
The electric tool is designed to be used as grinding
machine, sanding machine, wire brush, polishing
machine, carving or cutting tool. The combined tool
is very suitable for processing wood, plastic, stone,
aluminum shell, brass and steel.
ACTION
BEFORE OPERATION
A) Long press the speed adjustment button "-"(4B)
to display the battery level.
B) The battery must be fully charged before
using for the first time.
C) Charge the device (use charger)
Plug the charger plug into the power socket and
wait for a while. The battery indicator (6) will light
up and display the charging status.
LED status
The battery indicator is flashing
Battery charging
The power indicator stops flashing
Battery charging complete
When the battery is fully charged, unplug the
charger from the socket, and then pull the small
plug from the device.
12
The charger must use DC 5V 500mA to
1000mA switching power supply charger.
Do not charge the product for a long time,
and the charging time shall not exceed
3 hours. Otherwise, it may cause battery
leakage or explosion!
ASSEMBLY
Mounting accessories
Make sure that the machine is
turned off before installing
accessories.
Note: replace the accessories by
inserting them into the collet (or
chuck) as far as possible to minimize
exhaustion and imbalance.
Accessory assembly
Press and hold the spindle lock (3).
The collet chuck (1) can be undone
with chuck wrench (7). Put the
accessories in place.
Hold down the spindle lock when
fixing the collet chuck with chuck
wrench.
Do not press the spindle lock
button when the motor is
running.
OPERATION
Rotary tool
Press the on / off button (5) to turn on
the machine.
Use the speed adjustment button "+"
(4A) or "-" (4B) to adjust the speed
of the tool. Do not put the machine
down while the motor
is still running. Do not place the
machine on dusty surfaces. Dust
particles may enter the mechanism.
Too much load at low speed will
burn out the engine.
Note: after the tool stops working
for 15 seconds, the light will turn off
FIGURE
automatically.
Hold the tool correctly
For precision work (engraving):
•
pencil grip type (a)
For rough machining (grinding):
•
peeler handle type (b)
When you need to make the tool
•
parallel to the working surface
(e.g. using a cutting wheel): two-
handed golf grip type (c)
Accessory function operation
Grinding / sharpening
Sanding
Cleaning / polishing
Drilling
Engraving
Cutting
The best way to use combination tools and
their accessories
In order to use the accessories correctly, please use
the correct speed.
The five speed indicators (6) are equal to the numbers 1,
2, 3, 4 and 5 in the recommended speed setting below.
Note: ultimately, the best way to determine the correct
speed to process any material is to practice on a piece
of debris.
MAINTENANCE
See Fig. A
Your power tool requires no additional lubrication or
maintenance. There is no user serviceable parts in your
power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 32°F - 113°F .
The recommended ambient temperature range for
the charging system during charging is 32°F - 104 °F .
See Fig. B
See Fig. C
See Fig. D
See Fig. E,F
See Fig. G
See Fig. G
See Fig. H
EN
Tabla de contenido
