Optika Italy INSPECTION SYSTEMS Serie Manual De Instrucciones página 11

Only for IS-01SMD
Screw the 3D attachment on the lens thread on the microscope
body. (Fig. 5)
5. Connect the wireless mouse receiver in the USB port Ⓐ , the
HDMI cable in the port Ⓑ and the power supply jack in the
connector Ⓒ. (Fig. 6)
6. Connect a USB flash disk into the port Ⓓ.
• There is no ON-OFF switch on the microscope: when
the power supply is connected, the system starts up
automatically and begins projecting images onto the
monitor.
• It takes approximately 10-15 seconds for the system to
start up before the image is displayed.
Ⓒ
Page 11
Ⓐ
Ⓑ
Ⓓ
F ig. 5 F ig. 5
F ig. 6 F ig. 6