Idiomas disponibles
Idiomas disponibles
E-BIKE
Attaching to luggage rack
COMPATIBLE
A. Attach the bracket to the luggage rack:
1. Use the 4 screws (2 screws per side), 8 washers (4 per side) and 4
nuts (2 per side) to connect the lower plate
the luggage rack. Tighten firmly.
2. Attach the clutch (0) on the upper plate (2). Tighten firmly. Remark:
this product is applicable for luggage rack tube diameter from
10mm~16mm.
2
0
1
(1)
and the upper plate
(2)
to
B. Attach the adapter to the draw bar :
1. Open and remove the D-pin
(D-Clip)
extension arm.
2. Unscrew the adapter
(3)
and remove it from the extension arm
3. Firmly attach the adapter
(3)
to the draw bar as shown below.
D Clip
draw bar
4. Unscrew the safety strap
(0)
from the extension
arm and screw it firmly onto the draw bar.
C. Connect the draw bar to the luggage rack attachment bracket
4
1 - Loosen the pin
(4)
2 - Lift the locking hook
(5)
and position the adapter
3 - Close the locking hook (5), tighten the pin
cannot be raised.
Warning! Be sure to check that the locking hook
hitch ball and cannot be raised. Warning! Make sure that the safety strap is
securely fastened.
attached to the draw bar and remove the
Adaptater (3)
Extension arm
safety strap (0)
draw bar
Extension arm
safety
strap (0)
(3)
(5)
(6)
(3)
on the hitch ball
(6)
(4)
firmly so that the locking hook
(4)
is properly closed on the
(5)
