Uline H-6972 Manual Del Usuario página 2

BACK ASSEMBLY
1. Lay the two back panels on a flat surface.
(See Figure 1)
2. Place the right back panel (4) over the left back
panel (3), inserting the locking tabs into the
matching square holes. (See Figure 1)
NOTE: Locking tabs can be adjusted
open or closed with a screwdriver to
ease assembly.
Square Holes
Tabs
Figure 1
3. Once all the locking tabs are placed into square
holes, slide the back panels in opposite directions to
fully engage the tabs. (See Figure 2)
Figure 2
4. Tap the locking tabs down with a rubber mallet to
tighten the connections.
SIDE ASSEMBLY
1. With the back panels laying on a flat surface, lift the
outside edge of the right back panel (4) and slide
the L-shaped bend of the right side panel (2) under it.
(See Figure 3)
2. Insert locking tabs on the right side panel (2) into the
matching square holes in the right back panel (4).
(See Figure 3)
PAGE 2 OF 12
Bend is up
4
3
ASSEMBLY
3. Once all locking tabs are placed into square
holes, slide the side and back panels in opposite
directions to fully engage the locking tabs.
Square Holes
4
3
Figure 3
Bend is up
4. Tap each of the locking tabs down with a rubber
mallet to tighten the connections.
5. Repeat steps one through four with the left side
panel (1).
BOTTOM ASSEMBLY
1. Position the kick plate (9) as illustrated and begin
installation by lifting its right end upwards inside the
channel on the right side panel (2). (See Figure 4)
2. Push the kick plate upwards until the crescent tab on
the side panel engages the square hole on the kick
plate. (See Figure 4)
NOTE: Ensure a tight fit. A loose connection
would result in an unstable unit.
Figure 4
2
4
Tabs
3
Square Holes
Tabs
Crescent Tab
Square Hole
2
IMPORTANT!
Make sure the bend
on the side panels is
on the same side as
the back panels.
1
9
0721 IH-6972