Idiomas disponibles

Idiomas disponibles

H-6570
6' LAGUNA BENCH
TOOL NEEDED
Power Drill
3/8" Spacer x 2
Left Leg x 1
NOTE: Two people are required to assemble
this bench.
CAUTION! Do not drive attachment screws too
deeply, as the screw could protrude through
slat on the seating side of bench.
1. Verify all parts are present before beginning.
2. With one person holding the left leg and another
person holding the right leg, insert a rounded-edge
board between each leg, in line with the front of
the legs. From underneath, attach the front board
to the supports by fastening screws through the
pre-drilled holes on the underside of the leg. Do not
overtighten. (See Figure 1)
PAGE 1 OF 6
1-800-295-5510
uline.com
Two Person Assembly
Phillips Bit
(Optional)
Seat and Back
Board x 6
Center Leg x 1
PARTS
Right Leg x 1
ASSEMBLY
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Front and Top Board
with Rounded Edge x 2
2" Screw x 64
Figure 1
1020 IH-6570
Tabla de contenido
loading

Resumen de contenidos para Uline H-6570

  • Página 3: Herramientas Necesarias

    H-6570 800-295-5510 uline.mx BANCA LAGUNA DE 6' HERRAMIENTAS NECESARIAS Dos Personas para el Broca Taladro Ensamble (Opcional) PARTES 2 Espaciadores de 3/8" 6 Tablas de Asiento y Respaldo 2 Tablas Frontal y Superior con Borde Redondeado 64 Tornillos de 2"...
  • Página 4: Continuación De Ensamble

    (Vea Diagrama 4) 6. Repita el paso 4 para todas las tablas restantes, utilizando los espaciadores para alinearlas y apretarlas. Diagrama 4 NOTA: La Tornillería de Instalación H-6681 se vende por separado. 800-295-5510 uline.mx PAGE 4 OF 6 1020 IH-6570...

Tabla de contenido