Installation Instructions - Beeper AutoLight ALX9 Manual Del Usuario

INSTALLATION INSTRUCTIONS

• Wiring: Carefully check the various connections before final connection and take care to insulate the wires
that are not used.
• Luminosity sensor: Install the luminosity sensor on the windshield and be sure that it is away from
potential dark zones.
• Control box: Install the control box at an easily accessible place under the dashboard, if you need to adjust
the sensitivity.
USE OF THE SYSTEM
1. Switch ON: Press on the "
2. Switch OFF: Press on the "
inactive.
3. Adjustment of the time of lighting of the headlights: Press 1 time on the "
the sensor, the "20s" LED flashes to indicate that the headlights will remain lit 20 seconds. / Press 2 times on the
" " button of the sensor, the "30s" LED flashes to indicate that the headlights will remain lit 30 seconds. / Press
3 times on the " " button of the sensor, the "40s" LED flashes to indicate that the headlights will remain lit 40
seconds. / Press 4 times on the "
another time on the "
4. Adjustment of the sensitivity of the sensor: Take care not to set this function inside, but solely
with natural light, in a ventilated space. To regulate this function, press on the " " button for 3 seconds, when the
system is active and when the vehicle is unlocked. The 3 LEDs will flash to indicate that the natural light is restored.
" button of the sensor, the button lights up to indicate that the system is active.
" button of the sensor, the button lights off to indicate that the system is
" button, no LED is flashing, which means that this function is disabled. / Press
" button, to return to the original setting.
9
" button of