Uline H-7558 Manual Del Usuario página 2

1. Verify the product is positioned in the desired location.
Mark the floor where holes will be drilled.
WARNING! Wear eye protection when
completing step 2.
2. Using a 1/2" diameter masonry drill bit, drill a hole
approximately 3" deep into the floor. (See Figure 2)
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt.
3. Clean out debris and dust from inside the hole. Fully
insert the anchor bolt through the mounting plate and
into the hole.
4. Slightly tap down the anchor bolt with a hammer if
needed. Slide washers onto anchor bolt. Tighten the
hex nut with 18 mm wrench until the anchor bolt is
secure.
5. Repeat for remaining anchors.
PAGE 2 OF 6
INSTALLATION
Figure 2
Anchor Bolt
1/2" Masonry
Drill Bit
1-800-295-5510
uline.com
0321 IH-7558