View Your Active Data Connections - Nokia X6-00 Manual Del Usuario

98 Connectivity
1 Select Menu
2 Open the access point group that has the desired WLAN access point, and select the
access point.
You can also define 802.1x or WPA/WPA2 settings when creating a new WLAN access
point.
3 Select WLAN security mode
4 Select WLAN security settings
authentication protocol (EAP) plug-in, or
same password must be entered on the WLAN access point device.
If you selected EAP, define the EAP plug-in settings according to the instructions
from your service provider.
Connections in WPA2 only mode are applicable to WPA2 enabled devices only.
The available options may vary.
Advanced WLAN settings
1 Select Menu
2 Open the access point group that has the desired WLAN access point, and select the
WLAN access point.
You can also define advanced WLAN settings when creating a new WLAN access
point.
3 Select Options
IPv4 settings — Enter the IP address of your device, the subnet IP address, the default
gateway, and the IP addresses of the primary and secondary DNS servers. For these
addresses, contact your internet service provider.
IPv6 settings — Define the type of DNS address.
Ad-hoc channel (only for Ad-hoc) — To enter a channel number (1-11) manually, select
User defined.
Proxy server address — Enter the address for the proxy server.
Proxy port number — Enter the proxy port number.
The available options may vary.

View your active data connections

Select Menu Settings
>
In the active data connections view, you can see your data connections:
data calls
packet data connections
98
Settings and Connectivity
>
>
Settings and Connectivity
>
Advanced settings, and define the following:
>
and Connectivity
> Destinations.
WPA/WPA2 or 802.1x.
WPA/WPA2
> >
Pre-shared key
> Destinations.
Connection
>
EAP to use an extensible
to use a password. The
mgr..
© 2009 Nokia. All rights reserved.