Sanding Plate Brake; Sanding Surfaces - Worx Professional WU652 Manual Del Usuario

6

sANdINg plATE BRAkE

An integrated sanding plate brake reduces the speed when running
at no load so that scoring is avoided when placing the machine on the
work piece. A continuously increasing no-load speed over the course
of time indicates that the sanding plate brake is worn and must be
replaced by an authorized customer service location.
7

sANdINg sURFAcEs

Place the machine with the complete Sand paper on the surface to
be worked. Ensure uniform sanding pressure. Less sanding pressure
increases the sanding capacity and protects the machine and the
sanding tool. The removal capacity and the sanding pattern are
determined mainly by the selection of the Sand paper (grain size), the
speed of the sanding plate and the application pressure.
Rough sanding
Attach a Sand paper with coarse grain. Apply only light sanding
pressure to achieve increased material removal.
Fine sanding
Attach a Sand paper with fine grain. With moderate pressure, move
the machine in a circular pattern or alternately in lengthwise and
crosswise directions over the work piece. Do not tilt the machine to
avoid sanding through the work piece (e.g. when sanding veneer).
After finishing the work, switch off the machine and lift it from the
work piece.
Application table
The following table should be used only as a recommendation.
The most suitable combination for the work to be performed is
best determined by practical trial.
Material
Paint roughing
Paint touch-up
Paint removial
Soft wood
Hardwood
Veneer
Aluminum
Steel
Rust removal from steel
Stainless steel
9
Grain rough Variable
sanding/Fine speed Sanding plate
sanding control
180/400 3 Medium
120/240 5
40/80 4 Medium
60/240 5
60/180 5 Medium
240/320 4
80/240 4-5 Medium
60/240 4 Medium/Hard
40/120 6
120/240 4 Medium
Hard
Soft
Soft
Soft