Fracarro SIG7120 Instrucciones De Uso página 24

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
5.1.3 HEADEND SETUP AND EMULATION KTP MENU
Navigation in the headend
programming menus
HEADEND
SETUP
(not available)
Automatic acknowledgement of
the headend connected to the
TPE
Export the headend
configuration to another one
Restore the module
defaults setting
Not possible
Restart the module
EMULATION
KTP
NOTE: It is possible to modify the address only for the interconnection module SIG7900; after the modify it is
necessary to scan the headend to update the addresses of all module in the rack, otherwise disconnect and
reconnect the TPE from the headend to do the automatic scanning.
SIG7120
SIG7121
Set the input parameters of the
Measurements of the input signal
NAVIGATION
NAVIGATION OSD
HEADEND SCANNING
COPY
FACTORY SETUP
ADDRESS SETUP
MODULE RESET
Emulation of the KTP
programmer
EMULATION
KTP
Confirm the settings by pressing the
S key after the modules programmation.
5.1.4 SIG7120 / SIG7121 GENERAL MENU
Set the output parameters
COFDM (OUTPUT)
Transport Stream
Confirm the settings by pressing the
S key after the modules programmation.
SIG7120
SIG7121
Search module....
SIG7120
SIG7121
Invalid address
SIG7120
Devices
SIG7121
V = EXIT
key; save the settings by pressing the
Menù TS (Input)
TS (INPUT)
see pag.
Menù MEASURES
MEASURES
see pag.
key; save the settings by pressing the
24
Refer to the SIG7120/SIG7121
general programming menu
Automatic search of the headend
or the connected device. After
searching, the main menu can be
seen from the NAVIGATION
function
All
YES = V
Devices
All
YES = V
NO = X
The function is not
available for the
programming of the
SIG7120 module
Menù COFDM (Output)
25
see pag.
26-27
29
NO = X
Tabla de contenido
loading

Este manual también es adecuado para:

Sig7121

Tabla de contenido