Maintenance - Wattio THERMIC Manual

All manuals and user guides at all-guides.com
Once finalized the set-up Wizard, verify the correct performance of the Thermic.
In case of an incorrect initializing or if necessary, the Reset is pressed as follows, by a clip. The
initial configuration will be restored.

Maintenance

The user will be notified with an on screen signal that the Thermic runs out of battery. From
that moment will stop working, so it is advisable to change the batteries.
To replace batteries, before opening, the Thermic must be disconnected from the power
supply. It is highly recommended to switch off the electric supply system to proceed.
To remove the cover, just press the right side snap, without forcing it.
27