Wattio THERMIC Manual página 25

All manuals and user guides at all-guides.com
For a three wire thermostat circuits annul "Neutral"
(N) wire or "Ground lead". Cover the end of the cable
with insulating tape.
The phase cables must be connected to the terminal
block.
For a four wire thermostat circuits, it is highly recommendable to keep the old thermostat-
label, as there is a high variability in the wire set up, depending on the thermostat model.
Those are the most common examples:
1- Annul "Neutral" (N) wire and "Ground lead".
2- In case of 2 Neutral wires, join them together.
3- In case of 2 circuits, annul the Phase+ Neutral
wires supplying electricity to the thermostat.
3. Insert the batteries (AA alkaline batteries recommended).
It is very important to focus and place the batteries correctly following the indications in
the Thermic's case.
4. To place the front part of the Thermic, clip the left snaps and close the case following the
indication image and press until the right snap clicks. Press the cases following the
indications below until it closes correctly.
25