Adding Systems To Group Commands; Assigning To A System Already Programmed; Impulses Function; Changing The Battery - Mottura 5143 Manual De Instrucciones, Uso Y Mantenimiento

During the assigning procedure, the system is memorized in the transmitter also in the channel of Group "0".
Selecting the Channel "0", it's possible to simultaneously control all systems affiliated.
Note: You can't delete a system from Channel "0".
Using this procedure, ref. 5167 can be assigned to a system that already has a transmitter memorized.
1. select the channel that activates the system in the transmitter already memorized.
2. Press twice the P2 button of the transmitter already memorized in the system.
+
3. Use the button or the
be assigned.
4. Press once the same time
5. The system emits 3 beep. The transmitter is assigned.
Using this procedure the system "Impulses" function can be activated. When this function is activated the
system moves with an impulse when it receives a command of less than 2 sec. If it receives a command lasting
longer than this time, the system starts in continuous mode until it reaches the limit switch.
+
1. Use the button or the
2. Press once the same time
3. Press once the
4. Press once the
5. The system emits 3 beep. The system movement is by impulse.
6. To return to linear movement repeat from point 1
In order to work the R.F. Transmitters use one battery 3 V type CR2450 (ref. 5143, ref. 5155) or type
CR2430 (ref. 5148, ref. 5167).
To replace a battery follow the directions in attachments "A" – "B" – "C" .
Please note that the old battery cannot be disposed of with non-differentiated urban
waste but must be collected separately in accordance with the regulations set down by
the local authorities.
Transmitters ref. 5148 and 5167 can be fixed to the wall using either the fixing bolts (not supplied – see
attachment "D").
Transmission frequency: 433 MHz
•
Possibility of controlling up to 1 systems individually (ref. 5143, ref. 5148)
•
Possibility of controlling up to 15 systems individually and/or simultaneously (ref. 5155, ref. 5167)
•
Built-in R. F. antenna
•
Energy saving with auto shut-off
•
Battery: 1 x 3 V type CR2450 (ref. 5143, ref. 5155) or type CR2430 (ref. 5148, ref. 5167)
•
Dimensions: 45 mm x 130 mm x 12 mm (art. 5143, art. 5155)
•
80 mm x 85 mm x 14 mm (art. 5148, art. 5167)
12
A
DDING SYSTEMS TO GROUP COMMANDS
A
SSIGNING TO A SYSTEM ALREADY PROGRAMMED
-
button of ref. 5167 to select the channel number to which the system is to
+
and  buttons. of the new ref. 5167 transmitter.
I
MPULSES FUNCTION
-
button to select the channel number of system to set the function.
+
and  buttons.

button.

button (ref. 1805M28B) or the P2 button (ref. 1805M35R – ref. 1805M45R).
C
HANGING THE BATTERY
W
ALL MOUNTING
T
ECHNICAL
( . 5148 -
REF REF
C
HARACTERISTICS
Gb 6
. 5167)