Dremel 8260 Instrucciones De Funcionamiento Y Seguridad página 19

The purpose of the blinking green light
is to indicate that the battery pack is
fast-charging. It does not indicate the
exact point of full charge. The light will
stop blinking in less time if the battery
pack was not completely discharged.
If the green indicator light is "ON", the
charger is plugged in but the battery
pack is not inserted, or the battery pack
is fully charged, or the battery pack is
too hot or cold for fast-charging. The
charger will automatically switch to fast-
charging once a suitable temperature is
reached.
Service
Preventive maintenance performed by
un au thorized personnel may result in
misplacing of internal wires and
components which could cause serious
hazard. We recom mend that all tool
service be performed by a Dremel
Service Center.
Disconnect tool and/or charger from
power source before servicing.
Batteries
Be alert for battery packs that are
nearing their end of life. If you notice
decreased
significantly shorter running time
between charges then it is time to
replace the battery pack. Failure to do
so can cause the tool to operate
improperly or damage the charger.
Operating Instructions
To avoid accidents, always disconnect the tool and/or charger from the
power supply before servicing or cleaning.
NO USER SERVICE -
ABLE PARTS INSIDE.
SERVICE MEN:
tool performance
When charging several batteries in
sequence, the charge time may slightly
increase.
When the battery pack is fully charged,
unplug the charger (unless you're
charging another battery pack) and slip
the battery pack back into the tool.
Maintenance
D.C. Motors
The motor in your tool has been
engineered
dependable service. To maintain peak
efficiency of the motor, we recommend
it be examined every six months. Only a
genuine Dremel replacement motor
specially designed for your tool should
be used.
Cleaning
damage plastic parts. Some of these
are: gasoline, car bon tetrachloride,
chlorinated cleaning solvents, ammonia
or and household detergents that contain
ammonia.
Ventilation openings and switch levers
must be kept clean and free of foreign
matter. Do not attempt to clean by
inserting pointed objects through
opening
19
for many hours
Certain cleaning
agents and solvents
of