Product Specifications - Craftsman 315.HD2000 Manual Del Operador

PRODUCT
SPECIFICATIONS
Chuck ........................................................... 1/2 in. Keyless
Motor .................................................................. 19.2 V, DC
Switch .......................................................... Variable Speed
No Load Speed ........................ 0-375/0-1,600 r/min (RPM)
Hammer Speed ............................. 0-5,600/0-24,000 BPM*
Clutch ................................................................ 24 Position
Torque .......................................................... up to 465 in.lb.
*Blows Per Minute
KNOW YOUR HAMMER DRILL
See Figure 1, page L
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual
as well as a knowledge of the project you are attempt-
ing. Before use of this product, familiarize yourself with all
operating features and safety rules.
AUXILIARY HANDLE
Your drill is equipped with an auxiliary handle for ease of
operation and to prevent loss of control.
BIT STORAGE
Bits provided with the drill can be placed in the storage
area, located on the base of the drill.
BLOWS PER MINUTE
This tool features an impact speed of 0-5,600/0-24,000
BPM (Blows Per Minute). Blows Per Minute is the number
of impacts per minute.
DEPTH STOP ROD
A depth stop rod has been supplied with this product to
assist in controlling the depth of drilled holes.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
Your drill has a direction of rotation (forward/reverse/
center lock) selector located above the switch trigger for
changing the direction of bit rotation. Setting the switch
trigger in the OFF (center lock) position helps reduce the
possibility of accidental starting when not in use.
KEYLESS CHUCK
The keyless chuck allows you to hand-tighten or release
the drill bit in the chuck jaws.
LEVEL
The level is located on the top of the motor housing to
help keep the drill bit level during use.
QUICK MODE SELECTOR
The mode selector allows for full torque, hammer drilling,
and the ability to drive screws with user adjusted torque.
TORQUE ADJUSTMENT RING
Your drill has a 24-position clutch. The torque adjustment
ring can be turned to select the right amount of torque for
the application.
TWO-SPEED GEAR TRAIN
The two-speed gear train is designed for drilling or driving
at LO (1} or HI (2} speeds. A slide switch is located on top
of the drill for selecting either LO (1} or HI (2} speed.
VARIABLE SPEED
The switch trigger delivers higher speed with increased
trigger pressure and lower speed with decreased trigger
pressure.
CALIFORNIA PROPOSITION 65
_1_ WARNING: This product and some dust created by power sanding, sawing, grinding, drilling, and other construc-
tion activities may contain chemicals, including lead, known to the State of California to cause cancer, birth defects,
or other reproductive harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce
your exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are
specially designed to filter out microscopic particles.
6 - English