Water Softener - OLSON OLDW60X Manual Del Usuario

Water Softener

The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of
the water used. This is intended to optimise and customise the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Close the door, switch on the appliance.
2. Within 60 seconds after the appliance was switched on press the program
or more than 5 seconds to enter the water softener setting mode.
3. Press the program button again to select the proper set according to your local
environment, the setting will change in the following sequence: H1-> H2-> H3-> H4-> H5-> H6;
4. Press the Power button to end the setting mode.
The factory setting: H3
1) Every cycle with a regeneration operation consumes additional 2.0 litres of water, the energy consumption
increases by 0.02 kWh and the program extents by 4 minutes.
Please check the section 3 "Loading The Salt Into The Softener" of PART I: Generic Version, If your
dishwasher lacks salt.
NOTE:
If your model does not have any water softener, you may skip this section.Water Softener
The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form
on the dishes and utensils. The appliance is equipped with a special softener that uses a salt container
specifically designed to eliminate lime and minerals from the water.
67