Parameters Setup - BLAUSCAL DT Serie Manual De Utilización

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

STABILITY INDICATION
If the weights are being added continuously, the stability indication mode can be set in order to
deactivate the auto hold function.
TARE
Place the container on the weighing pan, when the reading is stable press the
will show "0.0kg". The function Tare can be repeatedly used. Negative figures will be displayed after
the tared weight (container's weight) is removed. The negative figure can be also tared.
WEIGHING UNIT SELECTION
Repeatedly press the
release it.
LOW BATTERY ALARM: If the battery's power is examined, the scale will auto turn off after "Lo.Bat"
is displayed.
OVERLOAD INDICATION: When the weight exceeds "capacity + 9d" at the zero position, the
display will show the message "EEEEEE".
TURN OFF : Press the

PARAMETERS SETUP

1. Place the balance on a firm and flat surface.
2. When the balance is in off mode, press the
.Release the
M
3. Press the
key to set the parameter.
4. Press the
key to confirm and move to next parameter.
5. Press the
to exit.
There are three parameters to be set:
• Auto Turn Off time set.
-
0, Auto Turn Off disabled.
-
Set 1 to 9, means that the scale will auto turn off if not used (default value 3)
• Backlight modes:
-
0, backlight always off.
-
1, backlight always on.
M
key until the weighing unit you want is displayed, and then immediately
key to turn off the balance.
key and go on pressing the
M
and without releasing it press the
M
key for 3 seconds.
key, the display
key.
5
Tabla de contenido
loading

Este manual también es adecuado para:

Dt-60Dt-120

Tabla de contenido