EN
GOLIATH BENCH
USER'S MANUAL
YOU WILL FIND IN THE BOX:
1 Goliath Bench support body mount
1 360º basic clamp
1 Clip to x the clamp
2
1
1
GOLIATH 360º BASIC CLAMP
2
CLAMP PRESSURE
3
SIDE LOOP CLIP
4
HOLES FOR FIXING TO BENCH
DESCRIPTION AND TECHNICAL FEATURES:
Bicycle repair support to be xed on a workbench. This bracket can meet fork xing needs
for repair or assembly and as a handlebar cutting bracket.
Fixed height lift, 360º clamp performance
Maximum weight to bear: 40kgs
G-BENCH
ASSEMBLY INSTRUCTIONS:
MOUNTING THE CLAMP ON THE BRACKET:
1 - Remove the bracket from the box
3
2 - Remove the washer from the back of the clamp (1) by unscrewing the screw, insert the back of the clamp into the clamp holder. (Photo 1)
4
3 - Mount the clip (3) on the clamp holder.
4 - Replace the washer on the back of the clamp (1), so that the screw can be tightened tightly, tighten the loop (3) so that the clamp does not roll.
(Photo 2)
You already have the clamp mounted, the clamp must roll freely once the side loop (3) of the clamp holder is loosened and xed with the tightening of
the clamp.
INSTALLATION AND FIXING OF THE SUPPORT:
The support is designed to be anchored on a workbench with a height of 900 mm.
1 - To attach the bracket to the workbench, it has 4 holes (4), where depending on the type of bench cover you can x with screws for metal threading,
threading wood or through with nut and washer.
The recommended height to x the bracket is 1150 mm, from the ground to the center of the clamp.
For this you will have to have the height of the bank.
2 - Once screwed in the workbench the support will be operational.
3 - In this bench holder the bicycle can only be operated with the clamp at 180º because of the handlebar touching the bench.
Photo 1
Photo 2