Warnings In Installation And Assembly Works; Warnings In Maintenance Works - Catalonia Aqua Spa Manual De Instalación

SAFETY WARNINGS ENG
• During operation, some parts of the equipment are at dangerous electrical voltage levels. Work
on each element or equipment can only be performed once it has been disconnected from the
mains and having disconnected the start-up devices.
• The user should ensure that assembly and maintenance works are carried out by qualified and
authorised persons, and that they have carefully read the installation and service instructions.
• Safety in the operation of the machine can only be guaranteed if installation and service
instructions are followed.
• The limits indicated in the electrical control panel cannot be exceeded under any circumstances.
• Contact the Technical Service of the manufacturer or the local dealer of the manufacturer in the
event of malfunction or a breakdown.
• The Spa should be installed following current regulations applicable in each country, particularly
those referring to electrical safety.
• There is risk of flooding with this equipment, and therefore it should be installed in an area
prepared to collect and drain any water that may overflow (both under and around the spa), owing
to its use or possible leaks in any of the circuits. (See the Guarantee).
• The equipment should be installed in a place which has been properly prepared and where all
components of the Spa can be easily accessed. The guarantee does not cover work needed to be
carried out to install or replace the product. (See the Guarantee).

2.2. WARNINGS IN INSTALLATION AND ASSEMBLY WORKS

• During the electrical conexion with the equipment have special care in the layout of the cables
in the bypass box, make sure no pieces of cables are in the box after closing and that the ground
conexion is correctly done.
• Pay special care that no water enters in conctact neither with the pumps neither with the electrical
parts under tension.

2.3. WARNINGS IN MAINTENANCE WORKS

• Before carrying out any electrical or mechanical maintenance work, make sure that the machine
is disconnected from the mains, and that the start-up devices are blocked.
• Do not handle the equipment with wet feet.
5