Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PREFACE
Your ceiling fan may sometimes have wobble problem when operate due to irregularity in blades or the blade holder. Also, improper
assembly in the mounting system may cause some additional problem also bearing crooked. The following procedure to remedy such
problem is strongly recommended by us from our past experience in handling the wobble problem.
Dynamic blade balancing kit for ceiling fans
1.
Make sure that all blade are firmly screwed into the blade holder
2.
Make sure that all blades are firmly secured the flywheel and check pitch of blade holders all must be the same
3.
By looking up the fan from below, check and be certain that none of the blade holders are bent so that none of the blade is out
of position. A correction can be made by very gently bending the blade holder back into position
4.
By the simple use of a household yardstick blade tracking can be checked, out the yardstick up against the ceiling vertically and
even with the outside leading edge of a blade. Note the distance of the edges of the blade to t he ceiling; carefully turn the blade
slowly by hand to check the remaining blades. If blade is not in alignment, the blade holder may be gently bent up or down
to be in line with the other blades
If by following all the steps and the wobble problem is not solved, a dynamic balancing need to be done by the use of the balancing
kit. Follow the procedure listed below:
Turn the fan on and adjust the speed control (usually high speed) setting to the speed, which creates to greatest wobble.
Turn the fan off; select on blade place the balance clip on it. Halfway between the blade holder and the blade up on the
rear edge of the blade.
Turn the fan on, watch to see of the wobble is improved or worse. Then, turn the fan off again and move the clip to
another blade and test again. Repeat this process with all blades and then note that blade which is the most improved.
Move the clip back to the blade, which showed the most improvement. Move the clip inward and outward on this
blade and operate t he fan to find the position where the clip gives the most improvement
Next remove the clip and install a balancing weight to the top of the blade along the centerline near the point where
the clip was positioned.
Caution: stay clear of the blades if the clip for any reason is not secured, injury could result
12. Others
Have your product repaired by a qualified person
This electric product is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons
using original spare parts; otherwise this may result in considerable danger to the user.
Please contact the store which you bought the product for after sale services if question
P.11
Tabla de contenido
