Ottobock Runway HX RS2-K1 Instrucciones De Uso página 11

Warnings
•
lnstructions for use
Heel Bumper
Instructions for Use (R-720-092, Rev. J)
RS2-K1 Runway® HX
Runway_HX_A4.indd 11
Runway® HX Instruction for Use
Product Number: RS2-K1
 Wet or dirty environments may cause the ankle module to malfunction and make it
difficult to operate.
Never allow aggregates such as sand to remain in the foot shell.

If the ankle module is exposed to wet or dirty environments, it is recommended to

periodically clean and lubricate the module in order to minimize impact on module
performance.
o Disassemble from shell, rinse with fresh water and thoroughly dry.
o If corrosion or buildup has occurred, clean the ankle mechanism with solvent
(i.e., acetone, WD-40) and compressed air.
o Cycle the mechanism thru the entire range while cleaning.
o Lubricate the slide with light grease, or spray lubricant and wipe off excess.
Always use the foot with a foot shell. Failure to comply may cause premature wear,

loss of function, and/or product failure.
Always use the foot with a sock and shoe. Failure to comply may cause noise,

premature wear, loss of function, and/or product failure.
Do not attempt to adjust the ankle while standing, without a grab rail or other

appropriate fixed object for support.
Never attempt to loosen the bolts affixing the ankle mechanism to the keel.

Discontinue use and consult prosthetist if prosthesis starts to make any noise.

Do not share your prosthesis with others; it may cause damage to the device and/or

injury.
Inform your prosthetist if you lose or gain a significant amount of weight.

Test bumper placement
Temporarily attach at recommended location using pre-applied adhesive. Suggested
placement will stiffen the heel by approximately one category. If necessry, adjust anterior/
posterior placement to achieve desired stiffness.
Permanently bond
Lightly abrade carbon fiber with sandpaper, then clean with acetone. Remove temporary
adhesive on bumpers using a cloth with acetone. Do not soak bumpers in acetone. Bond
bumpers in pre-selected position using cyanoacrylate (Super Glue).
Page 4 of 4
English EU
| 11
11.02.2021 07:11:44