Installation Procedure - Yamaha SPM-K1 Manual De Instalación

INSTALLATION PROCEDURE

Make sure to leave adequate ventilation space around the unit and follow the instructions below.
Attach the large wall mount bracket to the wall.
In order to secure the unit to the wall, you will need to attach the bracket to the wall first in a manner befitting the
structure and quality of the wall.
Choose a location where the wall can bear the weight of the whole unit.
Before installing the bracket, make sure of the size (see "DIMENSIONS" on the first page of this manual).
Installation example
Washer
(commercially
available)
Choose a secure wall or beam to fasten the screws. Do not install them into walls mafe of weak
material that can easily come off, such as mortar or plywood wall panels. Loose screws could cause
the projector to fall, resulting in personal injury.
Attach the safety wire.
Choose a method (A or B) when attaching the safety wire. When you choose the method A, attach the safety wire using
M4 screws provided. (Some of the projectors have no screw hole depending on the date of manufacture.)
A
When attaching to the projector.
If you tighten the screws on the slant, the screw threads in the projector might be broken. Be careful when
using electric tools.
5~6mm Tapping Screw (commercially available)
In order to secure the unit to the wall, attach four (or more) tapping
screws using the outside of the holes in the wall mount bracket.
Installing into a dry Installing directly
wall. into a wall, etc..
25mm or more
25mm or more
Beam, etc. Dry wall
Safety wire
M4 screw
provided
Attach the
safety wires
to the left and
right sides of
the projector.
Rear panel of
the projector
B
When attaching to the small wall mount
bracket.
INSTALLATION PROCEDURE
Slip one end
through the loop at
the other end
Slip the safety
wire through a
hole in the
bracket
Repeat the same
procedure for the
other bracket.
E-3