Plidco Flange+Repair Ring Manual Del Usuario página 12

3.) Once the piston has been pushed to the bottom of the barrel, insert the selected sealant. Screw
on the 1/2" straight adapter, or the flexible hose adapter. Proceed to injecting sealant. When the
barrel is empty repeat step 2 and 3 to load more sealant. (See Figure 8)
4.) Once the injection of sealant is complete. Clean out the barrel and cap. All units can be
completely disassembled if necessary. Use a solvent compatible with the sealant used. Once
the sealant has been cleaned out of the barrel and cap, place them back into the storage case.
The Buna O-ring in the cap can be removed for cleaning. If the O-ring has been damaged
contact PLIDCO for a replacement.
Note: Replacement parts can be ordered through PLIDCO. Contact us at the number on the first page
for replacement parts.
Figure 8
Page 11 of 12 IP-008
Revision 1