SCANMASKIN 28 WS Manual página 98

Every 500 hours
For more detailed
information about
the 500-hour service
interwall check the
Service Manual
Every 500 hours
For more detailed
information about
the 500-hour service
interwall check the
Service Manual
Every 1000 hours
For more detailed
information about the
1000-hour service
interwall check the
Service Manual
98
This service is recommended to be performed by Scan-
maskin authorized workshop
 Change the v-ring seals that is fitted on the grinding heads
upper side. (570136)
 Change the rubber damper that is located on each grind-
ing head.
(910093)
 Open up the machine house and inspect main radial seal
(580312)
No dust should be inside the machine house.
 Check the main belt for wear.
 Check tension on the belt
 Clean and lubricate the gears and gear ring inside the ma-
chine house.
Only use approved grease from Scanmaskin. (570100)
Note this grease is only for transmissions and not for
seals.
Before closing the machine house, make sure to lubri-
cate the radial seal and the surface where the radial
seal is working against with grease. Use regular grease
type NLGI 2
This service is recommended to be performed by Scan-
maskin authorized workshop.
 Remove the grinding heads and change the three radial
seals (580334) that protects the bearings. Clean and lubri-
cate with grease before installing new ones. Use regular
grease type NLGI 2
 Change the main radial seal
(580312)
Before closing the machine house, make sure to lubri-
cate the radial seal and the surface where the radial
seal is working against with grease. Use regular grease
type NLGI 2
www.scanmaskin.com