Electrical Safety - SCANMASKIN 28 WS Manual

SCANMASKIN 32 WORLD SERIES
Faults must be immediately rectified.
Carry out the switch on and switch off operations in accordance with this Manual.
Before switching on the machine make sure that no-one can be endangered when the ma-
chine starts up.
Never operate the machine when not in its upright position.
Do not switch off or remove the exhaust and or the ventilation devices whilst the machine
is running!
All persons in the proximity of the machine must wear ear and eye protection as well as
safety shoes. In addition, the machine operator must wear close-fitting protective clothing.
Only use extension cables that are sized and marked in accordance with the overall power
consumption of the machine and the valid VDE guidelines.
See "2.6Electrical safety" for further information.
Make sure there is no debris in the work area.
Check the work area for screws or other hard objects in the concrete. Don't use the ma-
chine if there are any foreign objects stuck into the surface. Such objects must be removed
prior to operation of machine

Electrical safety

2.6
The power source must be equipped fuses according to the table in "1.1Electrical spec-
ifications". All cables used must be marked and rated according to the fuses used.
Never connect the machine to a power source that does not provide protective earth!
Work on electrical equipment may only be undertaken by a skilled electrician or by trained
persons under the supervision of a skilled electrician as well as in accordance with the lo-
cal electrical engineering regulations.
Use only extension cables, that are used for extending the main cable, that are sized and
marked in accordance with the overall power consumption of the machine and the valid
VDE guidelines.
The electrical equipment for the plant must be inspected regularly. Defects such as loose
connections or scorched cables must be rectified immediately. Call as skilled electrician or
out customer services.
A second person must be in attendance whilst the electrical engineer is working on the
equipment.
The work area must be secured against any third party entering the work area. Follow local
electrical engineering regulations while working on the machine. Never leave a machine
unattended. Use only tools that are insulated against electricity.
www.scanmaskin.com
ENGLISH
83