Replacing Parts/ Replacing The Hepa Filter - Nilfisk cfm 118EXP Instrucciones De Uso

REPLACING PARTS
REPLACING THE HEPA FILTER
1. Remove the wing nuts that secure the HEPA screen (Figure 1).
2. Pull off the screen surrounding the three posts.
3. Remove old HEPA cartridge by carefully pulling cartridge through the posts.
4. Remove the old foam gasket from around the exhaust port.
5. Place a new foam gasket around the exhaust port (Figure 2).
6. Carefully install new HEPA cartridge against the foam
gasket with the label facing out.
7. Reinstall the screen around the posts.
8. Tighten the wing nuts.
REPLACING THE MAIN FILTER
1. Release the latches "A" and remove the Motor Head "B" (Figure 3).
2. Raise one side of the filter and reach down under the filter
with one hand to remove split pin "D". This will release
the filter shaker lever "E" from the filter ring "F" (Figure 5).
3. Lift up of the filter and cut the ties (G) that attach the filter
to the ring "F"(Figure 5).
4. Unscrew clamp "H" and remove the upper ring "I" (Figure 4).
5. Mount the upper ring "I" onto the new filter and secure
the ring in place with clamp "H" (Figure 4).
6. Secure the Filter "C" to the ring "F" using the ties "G"
supplied in the new filter kit (Figure 5).
7. Place the new filter assembly inside the filter chamber and
reconnect the assembly using the split pin "D" (Figure 5).
8. Mount the motor head "B" onto the machine and secure
in place with the latches "A" (Figure 3).
9. Dispose of the old filter in accordance with all federal,
state and local regulations.
INSTRUCTIONS FOR USE
1
2
3
4
5
PAGE 6