Example Session - Dell PowerConnect 8100 Serie Guía De Introducción

Example Session

This section describes an Easy Setup Wizard session. The following values are
used by the example session:
NOTE:
There is no username, password, or ip address when the switch is unboxed
or set to factory defaults.
• SNMP is not enabled.
• The default user name, root, is accepted and a password of admin123 is
entered. The Wizard does not display the password as it is entered.
• The OOB management interface uses 192.168.2.1 for IP address
assignment.
NOTE:
In the example below, the possible user options or default values are
enclosed in [ ]. If you press <Enter> with no options defined, the default value is
accepted. Help text is in parentheses.
The following example contains the sequence of prompts and responses
associated with running an example Dell Easy Setup Wizard session, using
the input values listed above.
After the switch completes the POST and is booted, the following text is
displayed:
(Unit 1-Waiting to select management unit)>
Applying Global configuration, please wait ...
Welcome to Dell Easy Setup Wizard
The Setup Wizard guides you through the initial switch
configuration, and gets you up and running as quickly
as possible. You can skip the setup wizard, and enter
CLI mode to manually configure the switch. You must
respond to the next question to run the setup wizard
within 60 seconds, otherwise the system will continue
with normal operation using the default system
configuration. Note: You can exit the setup wizard at
any point by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within 60 seconds)? [Y/N] y
Starting and Configuring the Switch
23