Connections To Receiver - Carson Reflex Wheel Start Manual De Instrucciones

CONNECTIONS TO RECEIVER

Battery eliminator is installed in the receiver circuitry. The receiver
gets supplied with current through the drive battery that runs the
engine. NiMH battery from 6 V to 8.4 V can be used for the receiver.
Batteries of higher voltage may damage the receiver and servos.
Electronic speed controller
(not included)
Receiver
Do not connect a separate power supply
to the receiver!
GB // 16
Use only a speed controller which has the exclusive connector for
the BEC system.
Channel / „CH": Switching channel 0/100%
Aux: no switching channel / output 4.8-6V for example/LED light sets
AUX
CH3
CH2
CH1
Connector motor
Connector battery
Power switch On-/Off
Steering servo
Channel 1 (not included)
ATTENTION
Make sure that male and female
connectors have the correct polarity!