pump will pump water, after the water flowing out
for 30 seconds, press the pump control button " "
to the higher position, finally, clean the steam outlet
with wet sponge, but care not to be burnt!
9. Press and release the ON/OFF button " " to cut off
the power source.
Note: Please follow the operation as below if the
steam outlet is blocked: firstly turn the steam knob
to "O" position and make the coffee maker cool
down for about half an hour, then poke the steam
outlet for several times with a needle about 1mm in
diameter, finally, press down the steam button " " and
turn on the steam knob to check if the appliance can
produce steam normally when the steam indicator
(yellow) illuminates. Please contact the service
department if the appliance can not produce steam
after operate as above.
AUTOMATIC POWER OFF FUNCTION
The appliance will turn off automatically 29 minutes
after pressing ON/OFF button.
CLEANING AND MAINTENANCE:
1. Cut off power source and let the coffee maker cool
down completely before cleaning.
2. Clean housing of coffee maker with moisture-
proof sponge often and clean water tank, drip tray
and removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser.
Never immerse the housing in water for cleaning.
3. Detach the metal funnel by turning it clockwise,
get rid of coffee residue inside, then you can clean
it with cleanser, but at last you must rinse with clear
water. Do not wash the metal funnel in a dishwasher.
4. Clean all the attachments in the water and dry
thoroughly.
Note: Clean the appliance after every use in order to
make it work properly.
CLEANING MINERAL DEPOSITS
1. To ensure your coffee maker can operate efficiently,
internal piping is clean and the peak flavor of coffee,
you should clean away the mineral deposits left
every 1-2 months.
2. Fill the tank with water and descaler to the MAX
level (the proportion of water and descaler is 4:1,
details refers to the instruction of descaler. Please
use "household descaler", you can use the citric acid
(obtainable from chemist's or drug stores) instead of
the descaler (one hundred parts of water and three
parts of citric acid).
3. According to the program of preheating, put the
metal funnel (no coffee powder in it) and carafe (jug)
in place. Brew water per "PREHEATING".
4. Press down the ON/OFF button " " to turn on the
unit, the power indicator (red) will be illuminated,
you should press the pump control button " " to the
lower position, make sure the steam button " " is at
the higher position, when there is water flowing out
and close the pump by pressing the pump control
button " " again, and wait for a moment, the coffee
maker begins to be heated.
5. When the ready indicator (green) illuminates, it
shows the heating is finish. Pressing down the pump
control button " " to the lower position and make
make two cups coffee (about 2Oz). Then close the
pump and wait for 5s.
6. Press down the steam button " " to the lower
position, waiting for until the yellow indicator is
illuminated. Make steam for 2min, then turn the
steam knob to the "O" position to stop making
steam. Press the ON/OFF button " " to turn off the
unit immediately, make the descalers deposit in the
unit at least 15 minutes.
7. Restart the unit and repeat the steps of 4-6 at
least 3 times.
8. Then pressing and release the steam button "
" to the higher position, when the green lamp is
illuminated, press down the pump control button " "
to the lower position to brew until no descaler is left.
9. Then brewing coffee (no coffee powder) with tap
water in the MAX level, repeat the steps of 4-6 for 3
times (it is not necessary to wait 15 minutes in step
of 6), then brewing until no water is left in the tank.
10. Repeat the step of 9 at least 3 times to make sure
the piping is cleanly.