KNOW YOUR COFFEE MAKER
CONTROL PANEL
BEFORE THE FIRST USE
Check that all accessories are complete and the unit
is not damaged. Fill water into water tank to the MAX
level and brew water for several times without coffee
powder, then discard the water. Clean and dry all
detachable parts thoroughly according to the section
"CLEANING AND MAINTENANCE" .
USING YOUR COFFEE MAKER
1. Open the top cover and fill the water tank with
drinking water. The water level should not exceed
MAX level as indicated on the water level gauge.
2. Place the funnel into the funnel support, make sure
it is assembled correctly, otherwise the top cover
cannot be closed. Place the permanent filter in the
funnel.
3. Add coffee powder into permanent filter. Usually a
cup of coffee needs a level spoon of coffee powder,
but you may adjust according to personal taste. Close
the top cover completely.
4. Insert the carafe with handle closed onto warming
plate horizontally.
5. Plug the power cord into the outlet. If you
want to adjust the coffee strength, you can press
"STRENGTH" button once, and then the STRENGTH
indicator will illuminate in orange and the appliance
will brew thick coffee. If you do not want to adjust the
coffee strength, just follow the following operation
to brew normal coffee.
6. Press ON/OFF button, the ON/OFF indicator
illuminates in red. The LCD display indicates "AM
12:00", and then the appliance begins to work.
Note: The brewing process can be interrupted by
pressing the ON/OFF button at any time, and the
ON/OFF indicator will extinguish, indicating your
coffee maker is shut off.
Note: During brewing process, the buttons of
"PROGRAM","DELAY BREW" ,"HOUR" and "MINUTE"
are invalid.
7. The brewing process can be interrupted by
pressing the ON/OFF button at any time, the ON/
OFF indicator will extinguish. The appliance will
continue brewing once ON/OFF button is pressed
again.
Note: You can take out carafe, pour and serve at any
time. The appliance will stop dripping automatically.
But the time cannot exceed 30 seconds.
8. Remove out carafe to serve when finish brewing
(about one minute later after the coffee stops
dripping out.)
Note: the coffee you get will less than the water you
have added, as some water is absorbed by coffee
ground and adhere to the plastic.
9. When the process is finished, if you do not want
to serve immediately, keep the coffee maker is
energized, the coffee can be kept warm on the
warming plate. And the appliance will shut off
automatically after 40 minutes from the ON/OFF
button being activated if it has not been manually
disconnected at the completion of brewing. For an
optimum coffee taste, serve it just after brewing.
10. Always turn the coffee maker off and disconnect
the power supply when not use.
Note: pay attention to pour the coffee out, otherwise
you may be hurt as the temperature of coffee just
finished is high.
DELAY FUNCTION
If you do not want the coffee maker to start operation
immediately, for example now it is AM 8:10, you
hope that the coffee maker will automatically start
working at PM 1:00, first follow steps 1 to 5 of "USING
YOUR COFFEE MAKER", and then you can set the
automatic start function as follows:
1. Set the current time that is AM 8:10 by pressing the
buttons of "HOUR" and "MINUTE".
Note: The time cycle is 12 hours.
2. Press PROGRAM button once, ON/OFF indicator
flashes in green, the LCD display indicates "AM