Fala 75951 Manual De Instrucciones página 10

MACHINE SPECIFICATION
The sanitary pump with shredder is used to connect sanitary devices such as lavatories and washbasins for sanitary sewage
network. If can be installed for pumping with impurities in places where sewerage infrastructure requires forced circulation e.g.
in places below the connector or places, which are signifi cantly distant from the intake. Shredding function allows the pump to
intermittently pump waste water containing fecal matter. The device is designed for use only in households and may not be used
professionally, ie. in the workplace and for work to earn money. Correct, reliable, and safe operation of the tool is dependent on
proper use, therefore:
Prior to working with the device, you should read all the instruction and keep it around.
Attention! The device is intended only for pumping water containing fecal matters. It is prohibited to throw hygienic
articles such as: paper towels, sanitary towels, tampons and other similar products to toilets connected to the pump,
For any damage caused by failure to comply with safety regulations and instructions of this manual, the supplier is not responsible.
MACHINE EQUIPMENT
The pump is supplied in a complete state and requires no assembly. Correct assembly is required for the proper operation of
pump. It is required that the installation of water connections will be carried out by the qualifi ed plumber. Non-return valve nd band
clips are supplied with the pump.
TECHNICAL PARAMETERS
Parameter
Catalogue No
Rated voltage
Rated frequency
Electric insulation class
Degree of protection
Rated power
Rotational speed
Maximum capacity
Maximum water temperature
Maximum height of pumping
Diameter of the water connection
Weight
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fi re or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain infl ammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fi re in case of contact with infl ammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fi t the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodifi ed plug which fi ts the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and
disconnect the plug from the mains socket. Avoid contact of the power supply cable with heat, oils, sharp tools and
moving elements. Damage to the power supply cable increases the risk of an electric shock.
O R I G I N A L
10
GB
Unit
[V~]
[Hz]
[W]
[min ]
-1
[l/min]
[ O C]
[m]
[mm]
[kg]
I N S T R U C T I O N S
Value
75951
230
50
I
IPX4
600
3 000
140
90
6,5
2 x Ø40; 1 x Ø100
8