Kobalt SGY-AIR176NB Manual Del Usuario página 13

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
2. For a full spray pattern, turn spray pattern
adjustment knob (I) counterclockwise.
For a smaller pattern, turn spray pattern
adjustment knob (I) clockwise.
3. Loosen lock knob and turn turn the fluid
adjustment knob (D) fully clockwise until
closed.
4. Fill the Paint Cup (F) about 3/4 of the way
and secure the Cup Lid (G).
5. With the spray gun 6 in. to 10 in. away from
workpiece, spray a short burst while turning
the Fluid Adjustment Knob (D)
counterclockwise. Observe the spray
pattern on the workpiece and adjust the
Fluid Adjustment Knob (D) until desired
pattern/atomization is obtained.
NOTE
If the spray is too fine (caused by too
much air), reduce the air pressure or open
the Fluid Adjustment Knob (D) to spray
more paint. If the spray is too coarse or
spitting blobs, reduce the amount of paint
with the Fluid Adjustment Knob (D) or thin
the paint more (See Figure 5).
NOTE
Before spraying on workpiece,
practice a few minutes on a cardboard
target to ensure that the pattern size and
consistency are set correctly.
2
3
4
5
Pattern Consistency (Atomization)
13
I
D
Lid
G
Load paint
F
Paint too fine
Correct
Paint too coarse
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

0192525

Tabla de contenido